Hello to all RX7 Peeps!
07-24-14, 03:37 AM
#51
Rotating
Thread Starter
Hey guys, been a while since I posted but have done some much needed TLC to the sev after a couple of years of neglect.
Will let the pictures do the talking:
Sorry about the quality but will get some better ones once its back on the ground.
So from the back to the front, items are:
New 4.3 S2 Rx7 LSD Diff head (was 3.9)
New Upper & Lower Nolythene Control arm bushings
New UJ's on the D Shaft
6Lb Fly wheel dowel (bolt) jointed and clutch/pressure plate machined/resurfaced
Gearbox painted/seals/oil
Motor out and painted
Oil squirters deleted
Bit of detailing on motor
IDA filter replaced, carb cleaned, manifold painted, new springs, bits and pieces (will go in for a tune so may replace jets etc as runs a bit rich)
New Radiator lines & Cap
Exhaust wrapped and realigned
New Pulleys and belts! (Ah Yee yah)
New nolythene bushings on all front arms and steering joints + painting etc (already full adjustable height, camber and castor with brake upgrade etc etc)
Other bits painted like steering master and clutch slave etc
Misc items that I can't remember....so much stuff that eats it all up
All to go is to reassemble the interior and get a new steering wheel!!
Last but not least, a massive thanks to my mate Gian (Bridge it baby ( did a 300whp REW13B swap into a FB couple years back)) for all the work and help etc. Can't speak highly enough.
Anyway, enjoy these pics and there should be more to follow!!
Will let the pictures do the talking:
Sorry about the quality but will get some better ones once its back on the ground.
So from the back to the front, items are:
New 4.3 S2 Rx7 LSD Diff head (was 3.9)
New Upper & Lower Nolythene Control arm bushings
New UJ's on the D Shaft
6Lb Fly wheel dowel (bolt) jointed and clutch/pressure plate machined/resurfaced
Gearbox painted/seals/oil
Motor out and painted
Oil squirters deleted
Bit of detailing on motor
IDA filter replaced, carb cleaned, manifold painted, new springs, bits and pieces (will go in for a tune so may replace jets etc as runs a bit rich)
New Radiator lines & Cap
Exhaust wrapped and realigned
New Pulleys and belts! (Ah Yee yah)
New nolythene bushings on all front arms and steering joints + painting etc (already full adjustable height, camber and castor with brake upgrade etc etc)
Other bits painted like steering master and clutch slave etc
Misc items that I can't remember....so much stuff that eats it all up
All to go is to reassemble the interior and get a new steering wheel!!
Last but not least, a massive thanks to my mate Gian (Bridge it baby ( did a 300whp REW13B swap into a FB couple years back)) for all the work and help etc. Can't speak highly enough.
Anyway, enjoy these pics and there should be more to follow!!
08-05-14, 03:21 AM
#58
Rotating
Thread Starter
Thanks guys, couple more things need to happen and then she's all go.
Not looking forward to getting a warrant of fitness, need to get it to a garage that is not too fussed about noise haha!
Not looking forward to getting a warrant of fitness, need to get it to a garage that is not too fussed about noise haha!
Thread
Thread Starter
Forum
Replies
Last Post
